Molar conductivity calculation of Li-ion battery electrolyte based on mode coupling theory

A method is proposed to calculate molar conductivity based on mode coupling theory in which the ion transference number is introduced into the theory. The molar conductivities of LiPF6, LiClO4, LiBF4, LiAsF6 in PC (propylene carbonate) are calculated based on this method. The results fit well to the literature data. This presents a potential way to calculate the conductivities of Li-ion battery electrolytes.     

Surface Modification of Fine Particles with a SnO<Subscript>2</Subscript> Film by Using a Polyhedral-Barrel Sputtering System

Fine particles were modified with a thin film of SnO₂ by using a barrel sputtering system that is a dry process. The conditions for the preparation of SnO₂ were studied by reactive sputtering onto a glass plate substrate. The optimal conditions for the preparation of tetragonal SnO₂ were identified as 60% partial oxygen pressure and 1.0 Pa total gas pressure with the substrate at room temperature. Under the optimized conditions, the surfaces of Al flake particles were modified with a thin film of SnO₂. XRD and SEM/EDS analysis of the prepared samples showed that the Al particle surfaces were uniformly modified by a thin film of SnO₂ in all cases. The film thicknesses were 80, 130, and 180 nm at RF outputs of 195, 350, and 490 W. These measured thicknesses coincided with the values estimated from the interference colors of the samples.     

Characterization and complementation of a Pichia stipitis mutant unable to grow on d-xylose or l-arabinose

Pichia stipitis CBS 6054 will grow on d-xylose, d-arabinose, and l-arabinose. d-Xylose and l-arabinose are abundant in seed hulls of maize, and their utilization is important in processing grain residues. To elucidate the degradation pathway for l-arabinose, we obtained a mutant, FPL-MY30, that was unable to grow on d-xylose and l-arabinose but that could grow on d-arabinitol. Activity assays of oxidoreductase and pentulokinase enzymes involved in d-xylose, d-arabinose, and l-arabinose pathways indicated that FPL-MY30 is deficient in d-xylitol dehydrogenase (D-XDH), d- and l-arabinitol dehydrogenases, and d-ribitol dehydrogenase. Transforming FPL-MY30 with a gene for xylitol dehydrogenase (PsXYL2), which was cloned from CBS 6054 (Gen Bank AF127801), restored the D-XDH activity and the capacity for FPL-MY30 to grow on l-arabinose. This suggested that FPL-MY30 is critically deficient in XYL2 and that the d-xylose and l-arabinose metabolic pathways have xylitolas a common intermediate. The capacity for FPL-MY30 to grow on d-arabinitol could proceed through d-ribulose.     

新工科项目“地方(行业)高校化学类专业应对产业变化的升级改造研究与实践”的实施

This "emerging engineering education (3E)" project "Upgrade and Practice of Chemistry-related Majors of Local and/or Specialized University Responding to the Industry Changes" was supported by the Ministry of Education. To aim at the issue of how to upgrade the chemistry-related majors of a local and/or specialized university responding to industry changes, an investigation on local regional economy and industry changes was carried out, the capability requirements of 3E for talents were analyzed, and the training objectives, graduation requirements as well as the new teaching models were also studied for the major to meet the future requirements. The practical experience for 3E construction of chemistry-related majors by selected universities was suggested.     

2,8,9-三氧杂-5-氮杂-1-硼杂双环[3,3,3]十一碳烷的合成

本文报导了具有N→B配位键的2,8,9-三氧杂-5-氮杂-1-硼杂双环[3,3,3]十一碳烷的合成及性质。化合物(1)的制备已有报导,而化合物(2),(3)则为新的化合物。我们研究了它们的成环条件,制备的最佳条件及化学稳定性。     

镍氢动力电池用AB5型贮氢合金热处理工艺的研究

本文对镍氢动力电池用AB5型纳米晶贮氢合金热处理工艺进行了研究.分别采用X射线衍射、金相、PCI测试手段分析热处理后贮氢合金的微观结构与吸放氢动力学性能.贮氢合金的电性能测试结果表明,经过950℃×6 h热处理的贮氢合金,10C放电比容量可以达到241mAh/g,循环寿命大于500次,分别以7C,10C放电,高倍率放电率(HRD)为92.5%,85.2%.将贮氢合金粉组装成电池进行测试,2min后,放电平台电压为1.143V,以10C放电,300次循环后,电池容量衰减率较小.     

分数导数结合傅里叶最小二乘拟合处理含噪音的重迭信号

提出了一种含噪音重迭信号的综合处理方法 :先用傅里叶最小二乘法拟合噪音数据 ,然后对拟合后的信号求 2 .5次导数 ,在对模拟数据研究的基础上 ,讨论了求导后峰位漂移及其影响因素 ,给出了一个用于矫正峰位值的经验公式。用该方法对模拟和实际的紫外含噪音重迭信号进行处理 ,结果良好     

A new type of two-dimensional packed + capillary column GC system. I. Theory

Summary To match the need of high efficiency capillary column (plate number N₂, Plate height H₂ and carrier gas linear velocity U₂), a new high efficiency packed column (N₁, H₁ and U₁) at high carrier gas velocity with small capacity factor has been developed in the light of theoretical discussion of factors effecting the column efficiency utilization ratio.     

Synthesis and aggregation behavior of <Emphasis Type="Italic">N</Emphasis>-succinyl-o-carboxymethylchitosan in aqueous solutions

A simple and novel method was developed to successfully synthesize N-succinyl-O-carboxymethylchitosan (NSOCMCS) using N-acylation of chitosan with succinic anhydride. The NSOCMCS structure was characterized by Fourier transform infrared and ¹H nuclear magnetic resonance. The aggregation behaviors of NSOCMCS were studied using fluorescence spectroscopy, dynamic light scattering, and atomic force microscopy techniques. The critical aggregation concentration of NSOCMCS in water was determined to be 0.2–0.3 mg/ml. The apparent hydrodynamic radium of an NSOCMCS aggregate was dependent on the concentration. The aggregates demonstrated a much swollen association conformation in aqueous solution. The possible aggregation mechanisms for the NSOCMCS in water are discussed. Moreover, a driving force to form an open aggregation morphology was revealed in this study. Aggregation behaviors are important physicochemical properties of NSOCMCS, which impact the potential application in the biomedical field.     

Development of the FTIR properties of nano-structure silica gel doped with different rare earth elements,prepared by sol-gel route

Structural characteristics of pure silica gel (silica-xerogel, SiO₂) and silica gel doped with some rare earth elements (REEs) such as, praseodymium Pr³⁺, and Europium Eu³⁺, Erbium Er³⁺ and Holmium Ho³⁺ ions, with different concentrations ranging from 1 up to 6%, in the form of monolith materials were prepared by sol-gel technique, Using tetra-ethoxysilane as precursor materials, which are of particular interest for sol-gel integrated optics applications. Some structural features of sol-gel derived monolith are analyzed, namely the structure of nano-particle momolith samples, based on X-ray diffraction (XRD) and Fourier Transform Infrared (FTIR). We show that the XRD spectra of α-crystobalite are obtained for the pure samples at 1100°C and even by doping with the four REEs ions.